300W (2500W Equiv) LED Motion Sensor Floodlight - Warm White
Click to enlarge
300W (2500W Equiv) LED Motion Sensor / PIR Floodlight / Security Light - IP65 in Warm White Light
This is the very latest in low energy high quality outdoor floodlights. This LED floodlight gives a bright warm white (Yellowish White) light. These LED floodlights are also instantly bright with no warm up time just like a standard halogen floodlight.
The PIR motion sensor can be adjusted through 180 degrees left and right and 180 degrees vertically. The movement sensor has 3 adjustment settings to vary the sensitivity to movement distance, illumination time and the light level required to turn on and off.
Motion sensor with 120 degree detection angle, range max. 12m, response time of 9 seconds to 10 minutes adjustable dimmer switch from light to dark
These high power 300W LED floodlights are suitable for 110V and 240V applications.
For our full range of low energy LED floodlights please Click Here
These floodlights will be shipped via 24 hour delivery (Next Day Delivery) if ordered before 3:30pm
Fitting Colour: Black
Fitting Material: Aluminium Alloy / Toughened 5mm Glass (High Strengh Material)
Power Consumption: 300 Watt
LED Emitter: 300W - 360 LED SMD Module
Dimensions: 425mm (L), 325mm (W), 110mm (H)
Light Colour: Warm White (2800K-3200K)
Beam Angle: 120°
Working Temperature: -25° to 45° C
Power Factor: >90
IP Rating: IP65 (Waterproof)
Average Life: 50,000 Hours
Safety Approved: CE / RoHS
No UV or IR Radiation
These LED floodlights come with 30cm of cable fitted to the fitting.
Waterproof IP65, this means the LED floodlight is totally protected against dust and protected against low pressure jets of water from all directions - limited ingress permitted.
We strongly advise that any electrical work be carried out by a qualified electrician.
If you require a cable connector to add this floodlight to an existing cable or to lengthen the current cable we recommend the following: Please Click Here.
All our LED flood light range are factory sealed units and as such should not be opened as they do not contain any user replaceable components. Any attempt to open the units will void the warranty / guarantee and cause the units to fail early.
After these floodlights have been fitted it is worth checking that the installer has install this with the PIR and the 3 PIR dials facing the ground and not up, if they are facing up the unit will fail early as water will be able to access the PIR, this is the same with all PIR floodlights.
If you have a floodlight where the PIR / Motion Sensor does not appear to work, please reset the unit by turning the floodlight off for 15-20 minutes and then turning on again, this should reset the PIR / Motion sensor and fix any issue. Please make sure the 3 PIR dials are also facing down and not up to prevent moisture damaged (the motion sensor is IP44 rated).
NOTE – To comply with regulations, installation must be carried out by a suitably qualified competent person and in accordance with the current IEE Wiring Regulations (BS7671) and Building Regulations. A copy of the instructions must be left for the user/maintenance engineer for future reference.
Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below: